Asus-switcheroo xorg.conf.intel
From Hybridgraphics
Revision as of 09:25, 12 May 2011 by 87.93.107.172 (Talk)
Section "Module" Load "glx" Load "dri" EndSection Section "Device" BusID "PCI:0:2:0" Identifier "Device0" Driver "intel" # Option "NoAccel" "boolean" ## Disable or enable acceleration. Default: acceleration is enabled. # Option "SWCursor" "boolean" ## Disable or enable software cursor. ## Default: software cursor is disable and a hardware cursor is used for configurations where the hardware cursor is ## available. # Option "ColorKey" "integer" ## This sets the default pixel value for the YUV video overlay key. Default: undefined. # Option "CacheLines" "integer" # This allows the user to change the amount of graphics memory used for 2D acceleration and video when XAA acceleration is enabled. Decreasing this # amount leaves more for 3D textures. Increasing it can improve 2D performance at the expense of 3D performance. Default: depends on the resolution, # depth, and available video memory. The driver attempts to allocate space for at 3 screenfuls of pixmaps plus an HD-sized XV video. The default used for # a specific configuration can be found by examining the Xorg log file. # Option "DRI" "boolean" # Disable or enable DRI support. Default: DRI is enabled for configurations where it is supported. Option "AccelMethod" "UXA" Option "FramebufferCompression" "true" #This option controls whether the framebuffer compression feature is enabled. If possible, the front buffer will be allocated in a tiled format and compressed periodically to save memory bandwidth and power. This option is only available on mobile chipsets. #Default: enabled on supported configurations. Option "Tiling" "true" #This option controls whether memory buffers are allocated in tiled mode. In most cases (especially for complex rendering), tiling dramatically improves performance. #Default: enabled. Option "SwapbuffersWait" "false" #This option controls the behavior of glXSwapBuffers and glXCopySubBufferMESA calls by GL applications. #If enabled, the calls will avoid tearing by making sure the display scanline is outside of the area #to be copied before the copy occurs. If disabled, no scanline synchronization is performed, #meaning tearing will likely occur. Note that when enabled, this option can adversely affect #the framerate of applications that render frames at less than refresh rate. #Default: enabled. Option "XvMC" "true" #Enable XvMC driver. Current support MPEG2 MC on 915/945 and G33 series. User should provide absolute path to libIntelXvMC.so in XvMCConfig file. #Use slightly more energy to improve performance Option "MigrationHeuristic" "greedy" #Underclock while on battery power Option "DynamicClocks" "on" Option "DCCMode" "off" Option "IgnoreEDID" "on" #don't listen to strangers Option "TripleBuffer" "false" Option "EnablePageFlip" "on" Screen 0 EndSection Section "Screen" Identifier "Intel Screen" Device "Device0" Defaultdepth 24 SubSection "Display" Depth 24 # Virtual 1366 768 Modes "1366x768" "1360x768" "1024x768" "800x600" "640x480" EndSubSection EndSection